Environmental durability test of mobile mechanical and electronic equipment

The environmental durability test of mobile mechanical and electronic equipment can simulate specific environmental conditions to determine its service life under specified use and maintenance conditions, minimizing the risks of warranty, recall, loss compensation and other risks caused by design defects.
Zhongke Testing Reliability Experiment Center is equipped with durability tests of various mobile mechanical, electrical and electronic equipment against environmental conditions, and provides professional environmental durability test services for agricultural machinery, forestry machinery, and gardening machinery.

Machinery type: gardening machinery, harvesting/farming machinery, forestry machinery, tractors and attachments
Location of electrical and electronic equipment on machinery: weatherproof location (e.g. in the cab), weatherproof location, in the engine room, in or near the engine or transmission

Climatic environment test: low temperature and dry heat test, temperature mutation test, constant damp heat test, alternating damp heat test, corrosive gas test, solar radiation (ultraviolet) test
Mechanical environment test: particle impact test, mechanical impact test, random vibration test, sinusoidal (resonance) test
Other environmental tests: air pressure (altitude) test, enclosure protection level (IP code) test, chemical brush or spray test

GB/T 25392-2010 Agricultural engineering Electrical and electronic equipment Durability test to environmental conditions
ISO 15003: 2006 Agricultural engineering Electrical and electronic equipment Durability testing to environmental conditions
GB 2423.1 Basic environmental testing procedures for electrical and electronic products Test A: Low temperature test method
GB 2423.2 Basic environmental testing procedures for electrical and electronic products Test B: High temperature test method
GB 2423.3 Basic environmental test procedures for electrical and electronic products Test Ca: Constant heat and humidity test method
GB 2423.6 Basic environmental testing procedures for electrical and electronic products Test Eb: Crash test method
GB 2423.10 Basic environmental testing procedures for electrical and electronic products Test Fc: Vibration (sinusoidal) test method
GB 2423.22 Basic environmental testing procedures for electrical and electronic products Test N: Temperature change test method