Static compression test of vulcanized rubber

The vulcanized rubber static compression test can measure the short-time static compression performance of vulcanized rubber. Zhongke Testing Reliability Experiment Center has the ability to test the reliability performance of various vulcanized rubbers and provides professional static compression testing services for vulcanized rubber.

In terms of its vulcanization method, vulcanized rubber can be roughly divided into:
(1) Flat vulcanizing machine vulcanization: flat tapes such as conveyor belts and transmission belts;
(2) Vulcanizing tank vulcanization: rubber hoses, rubber rollers, rubber shoes, air bags, rubber strips, tapes, drum lagging, pipe linings, cables, etc.;
(3) Continuous vulcanization: sealing strips, pure rubber hoses, wires and cables, etc.;

1. Apply the specified static pressure to the upper and lower ends of the vulcanized rubber sample, and measure the load required for the sample to reach the specified compression deformation rate or measure the compression deformation rate and compression permanent deformation of the sample under the specified static load.
2. The test conditions can determine the compression deformation rate, load and compression speed according to the performance of the sample being tested. The compression deformation rate can be selected from 10%, 20%, 25%, 30%, and 40%; 25% is recommended.
The compression speed can be selected as (12±3) mm/min or (25±3) mm/min; the test results obtained at the two speeds are not comparable. The conventional compression speed is (25±3) mm/min.

HG/T 3843-2008 Vulcanized rubber Short-time static compression test method
GB/T 2941 Rubber physical test methods General procedures for specimen preparation and adjustment
HG/T 2369-1992 Technical conditions for rubber and plastic tensile testing machines