Environmental operation test of fire protection electronic products

Operational testing is used to determine whether fire-fighting electronic products meet functional requirements under environmental test conditions. The purpose is to test the product's ability to work normally in the use environment and verify the product's adaptability in this environment. The products were in normal working condition during the testing process. The environmental test of fire-fighting electronic products can determine the environmental operating adaptability of fire-fighting electronic products.
Zhongke Testing Reliability Experiment Center has environmental testing capabilities for various fire-fighting electronic products, and provides professional environmental operation test services for fire alarm equipment, alarm valves, fire communication equipment and other fire-fighting electronic products.

1. Fire alarm equipment: fire alarm triggering devices, fire alarm control devices, fire alarm devices, fire linkage control equipment; etc.
2. Alarm valve: wet alarm valve, dry alarm valve, deluge alarm valve, pre-action device, delayer, hydraulic sensor, hydraulic alarm bell, etc.
3. Fire communication equipment: fire alarm dispatcher, fire command and dispatch equipment, fire vehicle dynamic management device, etc.

High temperature (operation) test, low temperature (operation) test, constant damp heat (operation) test, alternating damp heat (operation) test, impact (operation) test, collision test, vibration (sinusoidal) (operation) test, water test

GB/T 16838-2021 Environmental test methods and severity levels for fire-fighting electronic products
GB/T 2423.1-2008 Environmental testing of electrical and electronic products Part 2: Test methods Test A: Low temperature
GB/T 2423.2-2008 Environmental testing of electrical and electronic products Part 2: Test methods Test B: High temperature
GB/T 2423.3-2016 Environmental Test Part 2: Test Method Test Cab: Constant Humid Heat Test
GB/T 2423.4-2008 Environmental testing of electrical and electronic products Part 2: Test methods Test Db: Alternating moist heat (12 h + 12 h cycle)
GB/T 2423.7-2018 Environmental testing Part 2: Test method Test Ec: Impact caused by rough operation (mainly used for equipment type samples)
GB/T 2423.16-2008 Environmental testing of electrical and electronic products Part 2: Test methods Test J and guidelines: Mold growth
GB/T 2423.18-2012 Environmental testing Part 2: Test method Test Kb: Salt spray, alternating (sodium chloride solution)
GB/T 2423.19-2013 Environmental testing Part 2: Test methods Test Kc: Sulfur dioxide test for contact points and connections
GB/T 2423.37-2006 Environmental testing of electrical and electronic products Part 2: Test methods Test L: Sand and dust test
GB/T 2423.38-2008 Environmental testing of electrical and electronic products Part 2: Test methods Test R: Water test methods and guidelines
0 GB/T 4208-2017 Shell protection level (IP code)