The filling machine purchased by a food company had serious quality problems and could not be used. It did not meet the technical requirements stipulated in the agreement, and a dispute arose with the equipment manufacturer.
was entrusted by the court to conduct an appraisal and analysis on "whether there are quality problems" with the filling machine involved in the case.
identification and analysis results: The
identification and analysis expert group discussed the relevant information and on-site investigation of the filling machine involved and conducted a comprehensive quality and technical analysis, and made the following suggestions and conclusions:
1, filling The machine system can be produced and run, but cannot be used normally;
2. The packaging accuracy of the filling machine system products does not meet the packaging accuracy specified in the contract, that is, the packaging accuracy is ≤ +1.5g (the accuracy pass rate is 57.9%);
3. The filling machine system has the following defects: the filling machine has powder leakage and dusting at both the coarse and fine filling stations; the filling accuracy of the filling machine does not meet the requirements stipulated in the contract; the operation reliability of the capping and capping machine is poor; the crooked cap causes the aluminum foil to fail to seal; the production speed (capacity) is low (6.5 bottles per minute), which does not meet the contract The agreed minimum speed requirements for fully automatic capping, capping machines and aluminum film sealing machines;
4. The configuration of the capping machine components is inconsistent with the contract, which will have an adverse impact on the capping quality. The diameter of the can sorting turntable is inconsistent with the contract, which has no actual impact on the operation of the filling machine system.
