Bucket elevator quality appraisal

bucket elevator is a tool used to vertically lift lumpy materials such as limestone, coal, gypsum, clinker, dry clay, and powdery materials such as raw meal, cement, coal powder, etc. that pass through the crusher. It is mainly used to transport powdery, granular, small pieces and other materials with low abrasiveness. It is a mechanical conveying equipment with a fixed device and is suitable for continuous vertical lifting of powdery, granular and small pieces of materials.
bucket elevator is widely used in various scales of feed mills, flour mills, rice mills, oil mills, starch mills, grain depots, ports and terminals for lifting bulk materials.
In bucket elevator quality appraisal cases, Zhongke Testing can provide bucket elevator quality appraisal services.

1. Structural inspection: Inspect the structure of the bucket elevator to ensure that key components are firmly connected and there are no obvious cracks, deformations and other structural defects.
2. Transmission system inspection: Check the transmission system of the elevator, including rollers, chains, drive shafts, etc., to ensure that they are in good working condition and have no obvious wear and looseness.
3. Bucket capacity inspection: Check the bucket capacity of the bucket elevator to ensure that the bucket capacity meets the design requirements and can meet production needs.
4. Operation test: Conduct a trial operation test on the bucket elevator to check its operating status, noise and vibration levels to ensure that it operates normally and has no abnormalities.

JB/T3926-2014 Vertical fighting lifter
GB/T 37519-2019 Food oil machine
GB/T 35152-2017 Cement kiln tail wire-laying lifter
GB/T 37513-2019 Food oil machine
GB/T 13561.3 - 2009 Port Continuous handling equipment safety protocol Part 3: Bringing transporter, ground-laying board transporter, and fighting lifter HTMLTAGOKEN2GKEN/T35152017 HTMTAGOKEN5JB/T 14349-2022 Feeding machine HTMTAGKEN6JC/T 460-2018

was entrusted by a company to conduct appraisal and analysis on the quality of the technical modification of the liquid lime kiln bucket elevator involved in the case "whether it complies with the contract, technical agreement and relevant standard requirements."
identification and analysis results:
The identification and analysis expert group discussed the relevant information and on-site investigation of the PVC materials involved in the case and conducted a comprehensive quality and technical analysis, and made the following suggestions and conclusions:
The gap between the bricks of the No. 1 lime kiln involved in the case does not meet the standard agreement; Failure to perform kiln drying measures after the renovation of No. 2 lime kiln was not in compliance with regulations. Local high temperature was the main reason for the erosion of refractory materials.