Quality appraisal of conveyor line equipment

Conveyor line is a general equipment widely used in industrial production. It is mainly used to transport materials from one place to another. Conveyor lines are divided into many types, such as belt conveyor lines, roller conveyor lines, aerodynamic conveyor lines, chain conveyor lines, etc. Different types of conveyor lines are suitable for different industries and production areas. The working principle of the
conveyor line is to place the materials on the conveyor belt or conveyor unit, and drive the conveyor unit through the driving mechanism, so that the materials are transported to the destination along the prescribed route. During the operation of the conveyor line, it is usually equipped with auxiliary equipment such as sorting equipment, control systems, and lighting equipment to realize functions such as monitoring, classification, and quantitative measurement of materials.
Zhongke Testing can provide quality appraisal services for conveyor line equipment.

Conveyor line equipment quality identification can be analyzed from the following aspects:
1. The reasons for belt conveyor slippage
are: a large number of water belt conveyor paths, overloading, insufficient belt tension, the belt being extruded by a fully loaded vehicle, and the friction coefficient does not match the design value and the actual value of the belt between the drive rollers.
2, belt conveyor
a. The materials
at the transfer point are mainly in the dropping hopper, guide trough, etc. For example, the belt conveyor is seriously overloaded, the belt conveyor baffle rubber skirt is damaged, the steel plate at the guide trough is designed to be away from the belt, and the rubber skirt often causes the material to break away from the guide. Slots etc.
b． Material when concave belt is suspended
concave section belt part When the radius of curvature of the concave part is small, the belt will be suspended. At this time, the belt is grooved and the belt leaves the grooved roller group, causing the angle of the belt groove to become smaller and some material to overflow.
c． Deviation of materials
When the belt conveyor deflects, the height of the two sides changes with the operation of the conveyor belt. Therefore, when the material changes, one side of the material is higher and the other side is lower, and the material is scattered from the lower part.
0

GB/T 10595-2009 Belt conveyor
GB 14784-2013 Belt conveyor Safety regulations
GB 22340-2008 Coal mine belt conveyor Safety regulations
GB/T 17119-1997 Continuous handling equipment Belt conveyor with carrying rollers Calculation of operating power and tension
JB/T 14179-2022 Roller stamping bearing seat for belt conveyor
JBT13730-2019 Belt conveyor Hydraulic tensioning device
JB/T 12919-2016 Light belt conveyor for finished goods
JB/T 10380-2013 Round tube belt conveyor
JB/T 7854-2008 Air cushion belt conveyor